Highpoint ROCKETRAID 2310 Guida Utente Scaricare il pdf (Pagina 59)

Linux Driver Support

4. When the “Diver Update Menu” is displayed, press “OK” and “back” for back

to installer.

5. Next. Select “back” to return to the installer.

6. Installation will now proceed normally. Refer to SLES Linux documents for

additional OS installation procedures.

Additional Installation Notes:

The system device mapping order is the same as the order shown in RocketRAID

2310 BIOS Setting Utility. If no other SCSI adapters are installed, the device marked

as “BOOT” or “HDD0” will be identified as /dev/sda, “HDD1” as /dev/sdb, “HDD2”

as /dev/sdc, etc. When creating mount points, /boot must be mounted on /dev/sda.

3 - Installing the RocketRAID 2310 Driver on an Existing System

If you are currently running SLES and would like to access drives or arrays attached

to the RocketRAID 2310 controller, follow the steps outlined below:

Note:

1. If a SCSI adapter is used to boot the system, make sure the RocketRAID

2310 controller BIOS loads/posts after the SCSI adapter’s BIOS. It may be

necessary to move the adapter(s) to another PCI slot.

2. The driver may work incorrectly on certain motherboards (such as DFI77B

KT400). For these motherboards, add the “acpi=off” kernel parameter in the /

boot/grub/menu.lst:

kernel (hd0,1)/vmlinuz root=/dev/hda1 acpi=off

initrd (hd0,1)/initrd

Step 1 Update Grub

If you are running an SLES SMP System, you must first update the /boot/grub

/menu.lst.

5-11

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 74 75

Nessun commento

Highpoint ROCKETRAID 2310 Guida Utente Pagina 59